Knowledge Base:  

What Honeywell Glass Break Detectors Work with the Vista-20p?


Last Updated: 11/06/2013
In short, all of them. 


If you're in the market for a traditional glass detector that'll get the job done without all the bells and whistles, take a look at the Intellisense FG-1625. Some people prefer an inconspicuous, low-profile detector. If you're one of them, check out the FG1625R or the flush mountable FG1625RFM. Both boast a sleek, rounded design that blends into almost any environment. 

However, the 5853 Wireless Glassbreak Detector is usually the model of choice. This battery-operated detector is easy to install and highly versatile due to its wireless design.  Check out some of Ademco's Glassbreak Detectors and choose which detector model best fits your needs.

It's important to note that the 6160RF Keypad/Receiver or the wireless expansion module is required for compatibility with the Vista 20P. To add more zones to your existing system, pick up the addressable 4219 8-Zone Expansion Module


Similar Products: 


Was this article helpful?

Comments:
 

Related Articles
 >

Where Do I Find my VISTA 20P Panel Revision?


 >

How Do I Program a Vista-20P Duress Code?


 >

How does the Vista 20P compare to the Vista 20PSIA?


 >

Can I add sirens to the Vista 20P? And if so, how many?


 >

How do I install the Honeywell GSMV4G and get it to work with my Vista 20P Control Panel?


 >

How do I run a GO/NO GO test on my Vista 20P?


 >

What are the device addresses for my Vista 20P?


 >

Can I use Compass Software to program my Vista 20P Control Panel?


 >

How many wireless transmitters will work with the Vista 20P?


 >

How do I connect power to the Vista 20P?


 >

How many keypads can I install with my Vista 20P?


 >

How many events can be stored in the Vista 20P event log?


 >

What is a security "event" on my Vista 20P?


 >

How does a Tuxedo Touchscreen Keypad work with my Vista 20P?


 >

How do I change the Partition 2 code for my Vista 20P?


 >

How do I connect devices to the Vista 20P?


 >

How do you connect a zone expander on the Vista 20P?


 >

How do I program a Vista 20P Control Panel?


 >

How many zones can the Vista 20P support?


 >

How do I add a glass break sensor to the Vista 20P?


 >

What revision chip do I need to make Vista 20P compatible with Total Connect 2.0?


 >

How many wireless devices can the Honeywell 5881ENH wireless receiver support?


 >

For how long does a VIsta 20P siren sound when it goes off?


 >

What does "exit now" message mean when I arm my security system in "stay mode"?


 >

What alarm systems are compatible with the wireless 5800Micra?


 >

How do you arm a Honeywell security system?


 >

When the alarm goes off on my Vista 20P control panel, will the system call my cell phone?


 >

Why is my Vista 20P displaying a "Check 100" message?


 >

Why does an "E8" message appear on my Vista 15P or Vista 20P Control Panel?


 >

Why won't the default installer code (4112800) let me access the programming menu on my Vista 20P Control Panel?