|
You are here: Knowledge Base > Vista 10P
Can a 7847i Internet Communicator be connected to the Vista 10P?Last Updated: 11/07/2013 |
Although the Vista 10P does lack some of the features that higher Vista Panels possess, it is compatible with the 7847i Internet Communicator. To install the 7847i Internet Communicator... Shut off power to the Vista 10P by disconnecting the AC transformer and the back-up battery. Open the 7847i's cover by pushing in the tabs located at the bottom of the device. Find the terminal strip located on the green circuit board. Terminals 3-6 on the 7847i must be connected to terminals 4-7 on the Vista 10P Control Panel using four-conductor wire. Connect: 7847i's 3rd terminal to the Control Panel's 5th terminal using the red wire. 7847i's 4th terminal to the Control Panel's 3rd terminal using the black wire. 7847i's 5th terminal to the Control Panel's 7th terminal using the yellow wire. 7847i's 6th terminal to the Control Panel's 6th terminal using the green wire. Mount the unit using screw and wall anchors. Insert an Ethernet cable into the 7847i's Ethernet port and connect the other end to your internet router. Shut the 7847i cover. Reconnect your control panel's battery power then its AC power to complete installation. Similar Products:
Vista 20P Control Panel IGSMV-TC2 Internet and GSM Communicator w/ Two Way Voice GSMV4G - Intellipath Series Digital Cellular Communicator |